Chat with us, powered by LiveChat Skip to main content
Echo360 Status: 

Charging the MobiView and Changing the MobiView Battery

Echo360
  • Updated

Charging the MobiView


The MobiView should arrive partially charged and ready to be installed. Turning Technologies recommends that MobiView and its digital pen are both fully charged prior to use in the classroom.
 

TIP

You can use the MobiView while it is charging.
 
  1. Carefully remove the plastic tab from the digital pen and place the pen in the recharging pen holder.
  2. Remove the MultiHub from the back of the MobiView. For convenience, store the MultiHub in the holder on the charging stand.
  3. Place the MobiView on the charging stand.
  4. Plug the USB cable into the power adapter and plug into the wall outlet. Allow approximately eight (8) hours to fully charge the battery.
Alternatively, the MobiView can be charged by connecting the device to a computer via USB cable. Allow approximately 12 hours to fully charge the battery if using this method.
 

Changing the MobiView Battery


MobiView uses a special rechargeable lithium battery that typically lasts two to three years with normal use. Fully charge and discharge the unit to maintain optimal battery life.
 
  1. Turn over the MobiView.
  2. Use a Phillips screwdriver to open the battery compartment.
  3. Remove the existing battery pack.
  4. Plug in the new battery connector to the battery compartment.
  5. Gently insert the new battery pack into the compartment.
 

WARNING

Before replacing the cover, hold down the battery connector wires to avoid pinching the wires.
 
  1. Replace the battery cover and allow the MobiView to charge for 8 to 12 hours.