AdjustIt 3 Stand

The AdjustIt3™ Stand provides a mobile solution to move from class to class and adjusts the height to accommodate all users. Compatible with a wide range of short throw projectors, the mobile stand includes wheels with brakes for greater stability.

Place the right column on its side with brackets facing up.
Insert both horizontal bars over the brackets. Attach to the right column by inserting two screws with two M8 washers into the pre-drilled holes on both horizontal bars. TIGHTEN EACH SCREW.
Carefully stand the right column.
Insert the horizontal bars into the left column brackets.
Insert two screws with two M8 washers into the pre-drilled holes on each Horizontal Bar and attach each bar to the left column. TIGHTEN EACH SCREW.
Insert one screw and one M8 washer into each pre-drilled hole on the front of the stand. DO NOT COMPLETELY TIGHTEN.
Attach the wall mount piece to the stand. TIGHTEN EACH SCREW.
Mount the board to the stand:
1. Use four screws and four washers to attach the board shelf to the bottom of the central structure. DO NOT COMPLETELY TIGHTEN.
2. Use two screws and two M8 washers to attach the handle to the central structure.
3. Mount the appropriate board:

DualBoard

Place the DualBoard over the center lip.
Use two screws and two M6 washers to attach the DualBoard brakes from the central structure to the top of the board.

Touch Board

Attach the Touch Board brakes to the board.
- NOTE: For 78 in. boards, place the brakes facing up. For 88 in. boards, place the brakes facing down.
Place the Touch Board on the board shelf.
Attach the brakes to the central structure.
Push the board shelf back to secure the board from kicking out.
Tighten the board shelf screws.
If necessary, use the handle to adjust the board height. Lift the handle up to raise the board. To lower the board, lift the handle and push down on the board shelf.